The LX 5G isoLINK installs inline between your control system and lighting devices to isolate electrical noise from fixtures that can damage your network. It provides up to 3kV of digital isolation, extends cable runs beyond 100 ft, and injects power from its included 24VDC supply. Required when using fixtures that introduce electrical noise onto the control connection.
Free shipping on orders over $500 USD
Low-cost lighting fixtures can feed electrical noise back through the control connection, disrupting communication and potentially damaging your digital lightLINK. The LX 5G isolates and extends your control network so your system stays clean.
Provides up to 3,000 volts of isolation between the control system and connected devices, blocking voltage spikes and electrical noise from reaching your network.
Extends cable runs beyond 100 ft, making it possible to connect devices across buildings, outdoor cable runs, and weather stations.
Includes a 24VDC power supply that injects power to downstream devices, ensuring reliable operation on long cable runs where voltage drops would otherwise cause issues.
Some lighting fixtures introduce electrical noise onto the control connection. The LX 5G is required to protect your digital lightLINK from fixture interference.
Supports MODBUS RTU at up to 115 kbps for reliable digital communication across isolated connections.
Installs inline with no configuration required. Connect power, plug in your cables, and your network is protected.
The LX 5G installs inline between the LINKS HUB and your lighting control devices, isolating noisy fixtures from the rest of your control network while extending range and injecting power.
Isolate fixtures that feed electrical noise back into the control network, protecting your system from interference caused by certain LED drivers.
Extend connections beyond 100 ft for outdoor cable runs, weather stations, or devices in separate buildings.
Protect your control network when running cables through electrically noisy environments or interfacing with high-power equipment.

Full intensity and spectrum control for digital LED fixtures from nine supported manufacturers.

Run and control up to four lighting channels from one device.

The central brain of your automated grow operation. Connect and power up to eight LINK devices.

Real-time canopy-level temperature and humidity monitoring with built-in PAR sensor.
Use the System Builder to configure your setup, or talk to an expert who will spec it for your rooms.